Application of new technologies and materials on the M-12 motorway
https://doi.org/10.22227/1997-0935.2023.8.1179-1185
Abstract
Introduction. The significance of the M-12 motorway under construction as an international transport route is analyzed. The expediency of the project implementation based on the interests of Russia is noted.
Materials and methods. Structural solutions for the roadway on the M-12 motorway were considered. Materials for each structural and functional layer of the roadway are given. A brief review of the experience of using asphalt concrete designed using the Superpave method abroad and in Russia is provided. The question of inefficient arrangement of expensive by composition and complicated by design technology layers of new asphalt concrete inside rather than in the cover of the pavement structure on the M-12 motorway is raised.
Results. Advantages and disadvantages of the Superpave technology are shown. The peculiarities of bituminous binder selection are analyzed. Organizational, constructive, material and technological measures for the implementation of the design granulometric composition of the mineral part in the technology of asphalt concrete by the Superpave method are presented. The reasoned criticism of application of a new type of bituminous binder and granulometric composition of asphalt concrete according to the Superpave method is given.
Conclusions. The necessity of further study and development of the technology of asphalt concrete by the Superpave method and materials with superabsorbent polymer additives for their effective application is noted. The issues of ensuring workability of materials with polymer additives and regulation of their application by standards are outlined.
Keywords
M-12 motorway,
road pavement,
Superpave asphalt concrete,
superabsorbent polymer,
bituminous binder,
granulometric composition,
efficiency
Supporting agencies: The authors would like to thank the anonymous reviewers, the Department of Urban Planning and Moscow State University of Civil Engineering.
About the Authors
S. V. Privezentseva
Moscow State University of Civil Engineering (National Research University) (MGSU)
Russian Federation
Russian Federation
Svetlana V. Privezentseva — Senior Lecturer of the Department of Urban Planning
26 Yaroslavskoe shosse, Moscow,129337
А. F. Ivanov
Moscow State University of Civil Engineering (National Research University) (MGSU)
Russian Federation
Russian Federation
Aleksandr F. Ivanov — Candidate of Technical Sciences, Associate Professor, Associate Professor of the Department of Urban Planning
26 Yaroslavskoe shosse, Moscow,129337
References
1. Radovskiy B.S. The current state of development of the American method of designing asphalt concrete mixtures Superpave. Road Machinery. 2008; 12-22. (rus.).
2. Radovsky B.S. The concept of eternal pavement. Road equipment. Catalog-reference book: Road equipment. 2011; 120-132. (rus.).
3. Kretinina M.O., Orekhov S.A., Dergunov S.A., Satyukov A.B. Modern approach to the design of asphalt concrete compositions. Young Scientist. 2017; 21-1(155):144-145. EDN YUHSYV. (rus.).
4. Vasilenko S.D. The design of the composition of asphalt mixes in the US by the method of superpave : technical recommendations (extract). St. Petersburg, ZAO “Code”, 2012; 25. (rus.).
5. Belyaew N.N. American Superpave system: checking on Russian roads. Automobile Roads. 2014; 6:62-64. (rus.).
6. Berilin A., Nikolskiy V., Krasotkina I. Experience using Superpave standards. Automobile Roads. 2016; 3:73-80. (rus.).
7. Kiryukhin G.N. Pros and cons of the superpave asphalt concrete design system. World of Roads. 2014; 74:51-54. (rus.).
8. Radovsky B.S. Superpave: requirements for stone material. Automobile Roads. 2014; 7:56-67. (rus.).
9. Radovskij B.S. “Superpejv”: proektirovanie sostava smesi. Automobile Roads. 2014; 9(994)46-59. (rus.).
10. Mukhametshina R.M., Koshkin I.A. Modern technologies of road construction. Technique and Technology of Transport. 2021; 1(20):16. EDN UCSTAN. (rus.).
11. Trautvain A., Akimov A., Denisov V., Lashin M. Features of the method of surrounded design of asphaltconcrete on superpave technology. Bulletin of BSTU named after V.G. Shukhov. 2019; 3:8-14. DOI: 10.34031/article_5ca1f62f6b9a09.67742444. EDN VVZUTB. (rus.).
12. Mechtcherine V., Reinhardt H.W. Application of super absorbent polymers (SAP) in concrete construction. State-of-the-Art Report Prepared by Technical Committee 225-SAP. 2012. DOI: 10.1007/978-94-007-2733-5
13. Schröfl C., Snoeck D., Mechtcherine V. A review of characterisation methods for superabsorbent polymer (SAP) samples to be used in cement-based con struction materials: report of the RILEM TC 260-RSC. Materials and Structures. 2017; 50(4). DOI: 10.1617/s11527-017-1060-4
14. Mechtcherine V., Snoeck D., Schröfl C., De Belie N., Klemm A.J., Ichimiya K. et al. Testing superabsorbent polymer (SAP) sorption properties prior to implementation in concrete: results of a RILEM RoundRobin Test. Materials and Structures. 2018; 51(1). DOI: 10.1617/s11527-018-1149-4
15. Vandenhaute M., Snoeck D., Vanderleyden E., De Belie N., Van Vlierberghe S., Dubruel P. Stability of Pluronic® F127 bismethacrylate hydrogels: reality or utopia? Polymer Degradation and Stability. 2017; 146:201-211. DOI: 10.1016/j.polymdegradstab.2017.10.003
16. Snoeck D., De Belie N. Autogenous healing in strain-hardening cementitious materials with and without superabsorbent polymers: an 8-year study. Frontiers in Materials. 2019; 6. DOI: 10.3389/fmats.2019.00048
17. Cunha T.A., Agostinho L.B., Silva E.F. Application of nano-silica particles to improve the mechanical properties of high performance concrete containing superabsorbent polymers. 3rd International Conference on the Application of Superabsorbent Polymers (SAP) and Other New Admixtures Towards Smart Concrete. 2020; 211-221 DOI: 10.1007/978-3-030-33342-3_23
18. Kong X.-M., Zhang Z.-L., Lu Z.-C. Effect of pre-soaked superabsorbent polymer on shrinkage f high-strength concrete. Materials and Structures. 2015; 48(9):2741-2758. DOI: 10.1617/s11527-014-0351-2
19. Mignon A., Vermeulen J., Snoeck D., Dubruel P., Van Vlierberghe S., De Belie N. Mechanical and self-healing properties of cementitious materials with pH-responsive semi-synthetic superabsorbent polymers. Materials and Structures. 2017; 50(6). DOI: 10.1617/s11527-017-1109-4
20. Wang J., Mignon A., Snoeck D., Wiktor V., Van Vliergerghe S., Boon N., De Belie N. Application of modified-alginate encapsulated carbonate producing bacteria in concrete: a promising strategy for crack self-healing. Frontiers in Microbiology. 2015; 6. DOI: 10.3389/fmicb.2015.01088
21. Pelto J., Leivo M., Gruyaert E., Debbaut B., Snoeck D., De Belie N. Application of encapsulated superabsorbent polymers in cementitious materials for stimulated autogenous healing. Smart Materials and Structures. 2017; 26(10):105043. DOI: 10.1088/1361-665X/aa8497
22. Wyrzykowski M., Igarashi S.-I., Lura P., Mechtcherine V. Recommendation of RILEM TC 260-RSC: using superabsorbent polymers (SAP) to mitigate autogenous shrinkage. Materials and Structures. 2018; 51(5). DOI: 10.1617/s11527-018-1241-9
Review
For citations:
Privezentseva S.V., Ivanov А.F. Application of new technologies and materials on the M-12 motorway. Vestnik MGSU. 2023;18(8):1179-1185. (In Russ.) https://doi.org/10.22227/1997-0935.2023.8.1179-1185
Views:
867
Email this article 